INTERACTIVE DEMO MODE
All data is simulated. Adjust values in the Demo Controls panel below.
🎮 Demo Controls
Adjust these sliders to simulate sensor readings and see how PumpLogic responds.
45.0°F
12.80 V
22.4 inHg
Click to simulate sensor disconnect. Pump stops when sensors are stale.
Toggles the orange sync banner so you can see how it looks and works.
📊 Status
Demo Pump
Battery0%WiFi
⚠ Time not synced — Click or use Set Time in Settings.
🌡 Temp °F
45.0 °F
🔋 Voltage
12.80 V
💧 Vacuum
N/A
⚙ Relay
🛡 Battery Protection
Normal
📅 In Schedule
Yes
📈 Today Temp Range
33.2° — 48.7°
📈 Today Volt Range
12.18V — 13.42V
📈 Today Vacuum Range
— — — inHg
⌛ PumpLogic Uptime
0m
⏱ Relay Runtime Today
1h 30m
⏱ Relay Runtime Lifetime
148h 22m
Last updated: --:--:--
⚡ Charge Recovery
Duration of Charge: 4 hour(s)
Charge voltage target: 14.6 V
Waiting for voltage to reach 14.6 V...
🎛 Manual Control
Force ON: Turns the relay on for the ON Duration time, then resumes automatic cycling. Force OFF: Turns the relay off immediately and resumes automatic cycling. Charge Recovery: Initiates charge recovery using saved settings. Pump is disabled until recovery completes. Reboot: Restarts the device.
📶 Network
SSID
PumpLogic-D988
Gateway / Dashboard
192.168.4.1
🌐 mDNS
pumplogic.local
🔑 MAC Address
48:27:E2:FC:D9:88
📱 Your IP Address
192.168.4.2
🏷️ Device Name
🕐 Current Time
—
🔄 Last RTC Sync
—
After changing the SSID or password, reconnect to the network. If you have trouble connecting, try rebooting the device.
Leave date/time blank to keep current RTC time. The RTC module retains time across reboots.
🔋 Battery Charge/Discharge
● Above cutoff● Below 11.8V● Charging
↔ Swipe or scroll to see full 24 hours
Readings are every 15 mins for a max of 24 hours. Persists across reboots.
🪫 Battery Health
Cycles
47
Avg DoD (30d)
23%
Deepest
68% on 03-12-2026
Cycle = full ≥80%→≤20% discharge edge. Reset when replacing the battery.
🌡 Temperature Over Time
↔ Swipe or scroll to see full 24 hours
Readings are every 15 mins for a max of 24 hours. Persists across reboots.
💧 Vacuum Over Time
Vacuum sensor disabled
↔ Swipe or scroll to see full 24 hours
Readings are every 15 mins for a max of 24 hours. Persists across reboots.
⚙ Settings
SETTINGS MANAGEMENT
Save as Default stores your current settings. Restore loads saved defaults (or factory if none saved). Settings are also auto-backed up every hour — use Restore Auto-Backup to recover.
WiFi SSID, password, and Set Time are configured in the Network card and are not included in export/import.
